中科百科：新到的藥品穩定性試驗箱切勿馬上通電

    在我們系列產品中，藥品穩定性試驗箱制冷壓縮機的運行是需要潤滑油脂保護的，因此工廠在生產過程中向制冷系統里面加注了一定量的專用潤滑油，試驗箱制作完成以后潤滑油和制冷劑就被*封閉在制冷系統里面。藥品穩定性試驗箱在被搬運到用戶實驗室之前，早已經過了數小時或幾天的顛簸、移動甚至傾斜，這時候試驗箱里的潤滑油就會順著管路流入換熱器的盤管中。少量潤滑油還會在顛簸、震動的作用下灌入壓縮機的壓縮腔，這樣試驗箱開機后就容易導致試驗箱制冷系統出現異常或者嚴重的引起癱瘓，所以為了保險起見，試驗箱放置4到5個小時后通電是正確的。

    同時，為了保證使用的正常和安全，壓縮機機頭旁邊配套的和冷凝器也要定期清掃，在使用一段時間后，要對藥品穩定性試驗箱進行一次衛生大清掃。同樣，試驗箱在保養過程中也要注意到一些問題，首先每月至少清潔一次，清潔藥品穩定性試驗箱時先切斷電源，用軟布蘸上清水或食具洗潔精，輕輕擦洗，然后蘸清水將洗潔精拭去;其次，為防止損害箱外涂復層和箱內塑料零件，請勿用洗衣粉、去污粉、滑石粉、堿性洗滌劑、開水、油類、刷子等清洗試驗箱。再次，箱內附件骯臟積垢時，應拆下用清水或洗潔精清洗，電氣零件表面應用干布擦拭，清潔完畢，將電源插頭牢牢插好，檢查溫度控制器是否設定在正確位置。最后，溫度藥品穩定性試驗箱長時間不使用時，應拔下電源插頭，將箱內擦拭干凈，待箱內充分干燥后，將箱門關好。